AstroStart Security System VSS-113 Guia de Instalação

MODEL VSS-113 Installation Guide This product is intended for installation by a professional installer only! Any attempt to install thi

4. Select a Feature. Press and release the Valet/Program switch the number of times corresponding to the feature you wish to change. For example, to

9 © 2006 Astroflex Electronics. – All rights reserved System Features Menus MENU #1 - BASIC FEATURES Items in bold text have been programmed to the

Feature Descriptions The features of the system are described below. Features that have additional settings that can be selected only when programming

MENU #2 - ADVANCED FEATURES 2-1 SIREN/HORN HONK: The system can be programmed to output pulses instead of a continuous output when the system is trig

Transmitter/Receiver Learn Routine The system comes with two transmitters that have been taught to it. The system can store up to four different trans

To exit the learn routine: One long chirp indicates that Learn Routine has been exited. Learn Routine will be exited if any of the following occurs: 

TABLE OF ZONES Zone No. Trigger type Input description 1 Instant H1/7 BLACK/WHITE - Connect to optional hood/trunk pins. 2 On-board shock sensor

Nuisance Prevention® Circuitry Nuisance Prevention® Circuitry bypasses any zone that triggers the system more than three times within a one hour perio

Wiring Quick Reference Guide PINK(-) CHANNEL 2 VALIDITY OUTPUT (MAY REQUIRE RELAY)RED(+) CONSTANT POWER INPUTRED/WHITE(+) SIREN OUTPUTORANGE(+) S

© 2006 Astroflex Electronics. – All rights reserved 1 Table of contents Primary Harness (H1) Wire Connection Guide ...

Primary Harness (H1) Wire Connection Guide This guide describes in detail the connection of each wire. Also included are possible applications of each

H1/4 ORANGE (+) Switched Ignition Input Connect this wire to the (+) 12 volts ignition wire. This wire is pre-wired to the starter kill relay and must

H1/9 GREY (-) 200 mA Dome-light Supervision Output © 2006 Astroflex Electronics. – All rights reserved 4 Connect the H1/9 wire to the optional dome-l

H1/12 ORANGE/BLACK (-) 500 mA Ground When Armed Output This wire supplies a (-) ground as long as the system is armed. This output ceases as soon as t

PROGRAMMING TOOL, 3-PIN BLACK PLUG The BLACK three-pin port is provided for programming of the unit. When using the programming tool, it is possible t

Light Flash Programming Jumper This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and the uni